Filter
Top Products
13
Security Measures
Do not input your password while holding down on Shift or Ctrl .
Use only the upper horizontal row of numeric keys to input your password.
Do not forget your password. If a password is forgotten, you will be unable to
use your computer. Contact Panasonic Technical Support.
When running the Setup Utility, do not leave your computer even for a short time.
Setting the User Password (enabling, changing, disabling)
1 Run the Setup Utility ( page 39)
2 Using and , select [Security]
3 Using and , select [Set User Password] and press Enter
4 <Only when the User Password has been set>
Enter your password at the [Enter Current Password] and press
Enter
5 Enter your password at the [Enter New Password] and press
Enter
To disable the User Password
Press only Enter
When the Supervisor Password has not been set, the User Password can
not be set.
Set the Supervisor Password if you have not done so. ( page 12)
NOTE
CAUTION
When you do not want the User Password enabled, changed, or disabled
without permission:
1 Using and , select [User Password Protection] and press Enter
2 Using and , select [Protected] and press Enter .
NOTE
Your password will not be displayed on the screen.
Limit your password to seven characters. Note that there is no distinction
between upper and lower case letters.
Only the alphabet keys or number keys can be used. Note that the space
bar and function keys cannot be used.
NOTE
6 Re-enter your password at the [Confirm New Password] and
press Enter
To disable the User Password
Press only Enter
7 At the [Setup Notice], press Enter
8 Press F10 and select [Yes], then press Enter