Filter
Top Products
53
Troubleshooting
E The message "[Recovery] is complete" will be displayed. Remove the Prod-
uct Recovery DVD-ROM, and press any key to shut down the computer.
4 Return the Setup Utility settings to their default values.
Return the Setup Utility to its settings at the time of purchase to ensure
proper setup of Windows.
A Turn on the computer, and press the
F2
key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password, and press
the
Enter
key.
B Press the
F9
key.
At the confirmation message, select [Yes] and press the
Enter
key.
C Press the
F10
key.
At the confirmation message, select [Yes] and press the
Enter
key.
The Setup Utility will close, and the computer will restart.
5 Setup Windows. (Î page 18)
6
Run the Setup Utility and change the settings where necessary
.
(The Setup Utility settings will return to their default values. Even the security settings
with the exception of the password(s), date and time will return to their default values.)
7 If you can connect to the Internet, perform Windows Update.
(
Î
“To Update this Computer to its Latest Version” in onscreen Reference Manual)
Changing the drive letter
You can change the drive letter for the DVD-ROM & CD-R/RW drive or hard disk drive
by the following steps.
z The C drive cannot be changed.
z The drive letter for A Drive, B Drive and C Drive cannot be changed. You also can-
not use a drive letter that is currently being used by another device, or a drive letter
that has already been allocated to a network drive.
Changing the hard disk drive letter
A Click [start] - [Control Panel] - [Performance and Maintenance] - [Admin-
istrative Tools], and double-click [Computer Management].
B Click [Disk Management] in [Storage].
C
Right-click a partition of the hard disk, and click [Change Drive Letter and Paths]
.
D Click [Change].
E Click [Assign the following drive letter], select a drive letter, then click [OK].
F Click [Yes] when the confirmation message is displayed.
Changing the internal DVD-ROM & CD-R/RW drive letter
(Î page 20)