Filter
Top Products
- 30 -
Connections
4When the camera and pan/tilt head are to be controlled by the AW-RP505 control panel
for transmitting composite signals
• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the transmission signal
selection setting that supports the analog/IEEE1394 card.
• Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP
connector with the multiport hub’s PAN/TILT CONTROL OUT connector.
• Use a coaxial cable (BELDEN 8281) to connect the unit’s CAMERA CONTROL IN connector with
the multiport hub’s CAMERA CONTROL OUT connector.
• Use a coaxial cable (BELDEN 8281) to connect the unit’s VIDEO OUT connector with the multiport
hub’s VIDEO IN connector.
• Use a 10BASE-T straight cable (UTP category 5) to connect the multiport hub’s PAN/TILT
CONTROL IN connector with the controller’s PAN/TILT CONTROL OUT connector.
• Use a coaxial cable (BELDEN 8281) to connect the multiport hub’s CAMERA CONTROL IN
connector with the controller’s CAMERA CONTROL OUT connector.
• Use a coaxial cable (BELDEN 8281) to connect the multiport hub’s PREVIEW OUT connector with
the controller’s PREVIEW IN connector.
• Connect the multiport hub’s VIDEO OUT connector to the color monitor’s VIDEO input connector.
• Check that the pan/tilt head and camera can be controlled by the controller.
Genlock signals must be supplied if
a multiple number of cameras and
pan/tilt heads are to be used.
Multi hybrid control panel:
AW-RP505
Multiport hub: AW-HB505
AC adapter:
AW-PS300A
Preview color monitor
Color monitor
Camera cable
(supplied)
Coaxial cable
(BELDEN 8281),
max. 33 ft. (10 m
)
Coaxial cable (BELDEN 8281),
max. 1640 ft. (500 m
)
Coaxial cable
10BASE-T
(equivalent to UTP
category 5) straight
cable, max. 33 ft.
(10 m)
10BASE-T
(equivalent to UTP
category 5) straight cable,
max. 1640 ft. (500 m)
DC cable
(UL Type SPT-2 2!16
AWG or UL Type NISPT-2
2!16 AWG, to be locally
purchased)