Panasonic AW-PH360N Network Card User Manual


  Open as PDF
of 52
 
- 45 -
Limiters
OFor the controller AW-RP605A
1. To set the upper limit position of the
travel range:
Using the controller, tilt the camera to
the position which is to serve as the
upper limit.
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 47 .
The setting is completed as soon as the
lamp of the TRACING/PRESET
MEMORY button 41 [LIMIT ON] comes
on.
To release the setting:
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 47 .
The setting is released when the lamp of
the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
2. To set the lower limit position of the
travel range:
Using the controller, tilt the camera to
the position which is to serve as the
lower limit.
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 46 .
The setting is completed as soon as the
lamp of the TRACING/PRESET
MEMORY button 41 [LIMIT ON] comes
on.
To release the setting:
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 46 .
The setting is released when the lamp of
the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
3. To set the left-most limit position of
the travel range:
Using the controller, tilt the camera to
the position which is to serve as the left-
most limit.
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 44 .
The setting is completed as soon as the
lamp of the TRACING/PRESET
MEMORY button 41 [LIMIT ON] comes
on.
To release the setting:
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 44 .
The setting is released when the lamp of
the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
4. To set the right-most limit position of
the travel range:
Using the controller, tilt the camera to
the position which is to serve as the
right-most limit.
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 45 .
The setting is completed as soon as the
lamp of the TRACING/PRESET
MEMORY button 41 [LIMIT ON] comes
on.
To release the setting:
While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 45 .
The setting is released when the lamp of
the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
 previous next