Filter
Top Products
Error Messages
65
For fax advantage assistance, call 1-800-435-7329.
Display
If the unit detects a problem, one or more of the following messages will appear on the display.
CALL SERVICE
L There is something wrong with the unit.
Contact our service personnel.
CARRIAGE ERROR
b
RELEASE
SHIPPING LOCK
L The shipping lock is locked. Unlock the
shipping lock (page 10). If the display
messages still remain after unlocking, there
is something wrong with the carriage sensor.
Contact our service personnel.
CHECK ADF CABLE
L The ADF cable is not connected correctly.
Check the connection (page 9).
CHECK DOCUMENT
L The document was not fed into the unit
properly. Reinsert the document. If
misfeeding occurs frequently, clean the
document feeder rollers (page 75) and try
again.
L Attempted to transmit a document longer
than 600 mm. Press {
{{
{STOP}
}}
} to remove the
document. Divide the document into two or
more sheets and try again.
CHECK MEMORY
L The memory (telephone numbers,
parameters, etc.) has been erased. Re-
program.
CHECK PAPER
L The recording paper is not installed or the
unit has run out of paper. Install paper and
press {
{{
{SET}
}}
} to clear the message.
L The recording paper was not fed into the unit
properly (page 72). Reinstall paper (page 14)
and press {
{{
{SET}
}}
} to clear the message.
L The recording paper has jammed near the
recording paper entrance. Clear the jammed
paper (page 70) and press {
{{
{SET}
}}
} to clear the
message. Do not install folded or heavily
curled paper.
CLOSE ADF COVER
L The ADF cover is open. Close it.
COVER OPEN
L The printer cover is open. Close it.
DIRECTORY FULL
L There is no space to store new entries in
navigator directory. Erase unnecessary
entries (page 35).
FAX IN MEMORY
L The unit has a document in memory. See the
other displayed message instructions to print
out the document.
FAX MEMORY FULL
L The memory is full of received documents
due to a lack of recording paper or a
recording paper jam. Install paper (page 14)
or clear the jammed paper (page 70).
L When performing memory transmission, the
document being stored exceeds the memory
capacity of the unit. Transmit the entire
document manually.
FILM EMPTY
L The film is empty. Replace the film with a new
one (page 11).
L The ink film is slack. Tighten it (page 12) and
install again.
FILM NEAR EMPTY
L The remaining film is low. Prepare a new film
(page 6).