Filter
Top Products
ENGLISH-49
Adjustments and settings
48-ENGLISH
STILL MODE
(S-VIDEO/VIDEO only)
To reduce flickering of still images
(vertical flicker), set “STILL MODE”
to “ON”.
This should normally be set to
“AUTO”. If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
TV-SYSTEM AUTO
[
NTSC
[
NTSC4.43
[
PAL
[
PAL-M
[
PAL-N
[
SECAM
TV-SYSTEM
(S-VIDEO/VIDEO only)
Press the F or G button on the
remote control unit to select an item,
and then press the I or H button
to change the setting.
NOTE:
BWhen set to “AUTO”, the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.
NOTE:
BSet to “OFF” when playing
back moving images.
DETAILED SETUP
You can adjust the noise and flicker
of the projected images. Press the
ENTER button to display the
“DETAILED SETUP” menu.
DOT CLOCK
(PC only)
Periodic striped pattern interference
(noise) may occur when a striped
pattern such as the one below is
projected. If this happens, press the
I or H button to adjust so that any
such noise is minimised.
CLOCK PHASE
(PC/
YP
B
P
R
only)
Adjust the “DOT CLOCK” setting
first before carrying out this
adjustment. Press the I or H
button to adjust so that the noise
level is least noticeable.
NOTE:
B
If using this projector in places
such as cafes or hotels to display
programes for a commercial
purpose or for public
presentation, note that if the
aspect ratio (16:9) selection
function is used to change the
aspect ratio of the screen
picture, you may be infringing the
rights of the original copyright
owner for that programe under
copyright protection laws
.
B
If a 4:3 picture is projected onto
a 16:9 screen, distortion may
occur around the edges of the
picture so that part of the picture
is no longer visible. Programes
which have 4:3 aspect ratios
should be viewed in 4:3 mode to
give proper consideration to the
aims and intentions of the
original programe’s creator.
POSITION
(PC/
YP
B
P
R
/S-VIDEO/VIDEO only
)
Moves the picture position.
Press the ENTER button to display the
“POSITION” screen.
Press the I or H button to move the
picture horizontally.
Press the F or G button to move the
picture vertically.
HORIZ.
32
VERT.
16
NOTE:
BIf signals with a dot clock
frequency of 100 MHz or
higher are being input,
interference may not be
completely eliminated when
the “DOT CLOCK” and
“CLOCK PHASE” adjustments
are carried out.
DETAILED SETUP
DOT CLOCK 32
CLOCK PHASE 16
SELECT ENTER RETRN
DETAILED SETUP
STILL MODE OFF
ADJ RETRN
When a PC/YP
B
P
R
signal is being input
When an S-VIDEO/VIDEO signal is
being input
AUTO SIGNAL
This should normally be set to “ON”.
ON
“AUTO SETUP” will be carried out
when the input signal is changed to
“PC”.
OFF
“AUTO SETUP” will not function
when the input signal is changed to
“PC”.
Other settings
OTHER SETUP
AUTO SIGNAL ON
TV-SYSTEM AUTO
FRONT/REAR FRONT
DESK/CEILING DESK
HIGHLAND OFF
LAMP RUNTIME 10H
SXGA MODE SXGA
CTRL PANEL VALID
NR OFF
SELECT ADJ RETRN