Panasonic PT-P1SDU Projector User Manual


 
ENGLISH-1716-ENGLISH
Preparation
Remote control unit
Projector control panel
$SD operation buttons (pages 18 and 35)
These buttons are used for operation when the SD selection screen is being
displayed and when files in the SD memory card are being played back.
%POWER button (pages 26, 28 and 29)
This button is used to turn the power on and off. This button on the
projector illuminates red when the projector is in standby mode, and it
illuminates green when a picture starts to be projected.
&INPUT button (page 27)
This button is used to switch the input signals from the connected
equipment.
'Illumination sensor (page 44)
This sensor detects the luminance when the “DAYLIGHTVIEW” function is
operating. Do not cover the projector and do not place any object on the
projector when using it.
(LAMP indicator (page 55)
This indicator illuminates when it is time to replace the lamp unit. It flashes
if a circuit abnormality is detected.
)TEMP indicator (page 54)
This indicator illuminates if an abnormally high temperature is detected
inside the projector or around it. If the temperature rises above a certain
level, the power supply will be turned off automatically and the indicator
will flash.
*MENU button (pages 40 and 42)
This button is used to display the “MAIN MENU”. When a menu screen is
being displayed, this button can be used to return to a previous screen or
to clear the screen.
+ENTER button (page 42)
This button is used to accept and to activate items selected in the on-screen
menus.
,Arrow (
FFGGII
and
HH
) buttons (page 42)
These buttons are used to select and adjust items in the on-screen menus.
-SHUTTER button (page 31)
This button is used to momentarily turn off the picture and sound.
.VOLUME +/- buttons (page 31)
These buttons are used to adjust the volume of the sound output from the
projector’s built-in speaker.
/STD (standard) button (page 43)
This button is used to reset the projector adjustment values to the factory
default settings.
0AUTO SETUP button (pages 27 and 30)
If this button is pressed while a PC signal is being projected, the position
of the image and the settings for “DOT CLOCK” and “CLOCK PHASE” will
be adjusted automatically.
#Input signal indicators
These indicators illuminate when a signal is being input to the connector
that has been selected using the INPUT button. The indicators flash when
no signal is being input to the connector that was selected using the
INPUT button and when signals that are not compatible with the projector
are being input.
(
)
'
Illumination
sensor and
LAMP/ TEMP
indicators
<on top of the
projector: page 14>
POWER
AUTO
SETUP
INPUT MENU
SHUTTER
VOLUME
ENTER
ROTAT E
RETURN
ENTER
STD
$
&
,
-
.
/
0
+
%
*
#$
%
&