Filter
Top Products
ENGLISH - 11
Preparation
Read this first
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
J INITIAL SETTING
1. Select the required language setting by pressing
IH, then press the ENTER button.
2. Select the minimum required settings to start the
projection.
Press the RETURN button to return to the language
setting menu.
Press F G to move through the menu items.
Press I H to select the required setting.
Press the ENTER button to complete the setting and
start the projection.
INSTALLATION
Select the required installation method.
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the fan
speed high.
OFF The fan speed is low.
ON The fan speed is high.
Minimum required setting screen
INITIAL SETTING
ENGLISH
SELECT
ENTER
PLEASE SELECT LANGUAGE
INSTALLATION
INITIAL SETTING
FRONT/DESK
HIGH ALTITUDE MODE
OFF
SELECT
ENTER
RETURN
SWITCH TO HIGH ALTITUDE MODE "ON" IF OVER 1400m(4593Ft).
FRONT/DESK
Setting on a desk/floor and
projecting from front
FRONT/CEILING
Mounting on the ceiling and
projecting from front
REAR/DESK
Setting on a desk/floor and
projecting from rear
REAR/CEILING
Mounting on the ceiling and
projecting from rear
NOTE:
• At 1 400 - 2700 m (4 593 - 8 858 ft) above sea level,
the setting must be ON.
• The loudness of fan noise depends on the HIGH
ALTITUDE MODE setting.
NOTE:
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialized. See “INITIALIZE ALL” on page 43.
You can change the each setting from the main menu. See “Menu Navigation” on page 30.