Filter
Top Products
Preparation
About Your Projector
ENGLISH - 14
Remote control
NOTE:
• Do not drop the remote control.
• Avoid contact with liquids or moisture.
• Use manganese batteries or alkaline batteries with the remote control.
• Do not attempt to modify or disassemble the remote control. Contact an Authorized Service Center for repairs.
• Do not keep pressing the remote control buttons as this may shorten battery life.
• Do not point the laser in other people’s eyes or stare into beam.
• See “Remote control operation” on page 25.
Power button
While the MAIN POWER is
on, switch between standby
mode and projection mode.
(page 21)
Project a laser pointer.
(page 28)
Display the main menu.
(page 32)
Navigate through the
menus with FGIH, and
activate the menu item
with the ENTER button.
(page 32)
Capture the projected image
as a frozen picture.
(page 27)
Reset some of the settings
to the factory default
settings. (page 27)
Assign the frequently use
functions from the options
for shortcut. (page 27)
Control to change the scale
by means of digital zoom.
(page 26)
Automatically adjust the
setting of SHIFT, DOT
CLOCK, CLOCK PHASE
and SIGNAL SEARCH for
the projected image of COMPUTER/
DVI signal. (page 25)
Switch the required input
signal button to select.
Return to the previous menu.
(page 32)
Turn off the projection
temporarily. (page 27)
Display the frozen image
while the display of
subsequent images
continues. (page 27)
Control to adjust the volume
of the speaker. (page 29)
These buttons are for network control. See the contents of the
provided CD-ROM for instructions. The COMPUTER
SEARCH button is for PT-F300NTU only.
Battery compartment
1. Press the tab and lift up the cover.
2. Insert the batteries according to the polarity diagram
indicated inside.
Attaching a hand strap
You can attach a favorite
strap on to the remote
control.
Top view
Remote control signal
emitters (page 25)
Laser pointer beam
emitter (page 28)
Remote control indicator
Pressing any button except the LASER
button, the remote control indicator will
flash. Pressing the LASER button, it will
lit.
(Shown as PT-F300NTU)