Filter
Top Products
Chapter 4 Settings — [SIGNAL LIST] menu
ENGLISH - 93
[SIGNAL LIST] menu
On the menu screen, select [SIGNAL LIST] from the main menu.
Refer to “Navigating through the menu” (x page 44) for the operation of the menu screen.
r Registered signal details
f A name can be set for each sub memory (x page 74).
f Memory number:
A1 (1-2)
When the signal of the address number (A1, A2, ...L7, L8) is registered.
Sub memory number
Registering new signals
After a new signal is input and the <MENU> button on the remote control or the control panel is pressed, the registration is completed and the
[MAIN MENU] screen is displayed.
Note
f Up to 96 signals, including sub memories, can be registered to the projector.
f There are 12 pages (eight memories of A through L, with eight memories possible on each page) for memory numbers, and the signal is
registered to the lowest number that is available. If there is no available memory number it will be overwritten from the oldest signal.
f The names to be registered are automatically determined by the input signals and memory numbers.
f If a menu is being displayed, the new signals will be registered at the instant they are input.
Renaming the registered signal
Registered signals can be renamed.
1) Press asqw to select the signal for which details are to be displayed.
2) Press the <ENTER> button.
f The [REGISTERED SIGNAL STATUS] screen is displayed.
f The input signal name, memory number, input terminal, frequency, synchronization signal, etc., are displayed.
f Press the <RETURN> button or the <MENU> button to return to the [REGISTERED SIGNAL LIST] screen.
3) Press the <ENTER> button.
f The [RENAME] screen is displayed.
4) Press asqw to select the text, and press the <ENTER> button to enter the text.
5) After the name is changed, press asqw to select [OK], and press the <ENTER> button.
f The registration is completed and the [REGISTERED SIGNAL STATUS] screen returns.
f When pressing asqw to select [CANCEL] and pressing the <ENTER> button, the changed signal name will not be registered and
an automatically registered signal name will be used.