Filter
Top Products
20
Screen Height Adjustment
The screen can be adjusted at 3 levels except for the lowest level. The lowest level of the board attachment frame is
designed for installation of the screen, so the printer cannot be attached at this level. Adjust the level of the screen
unit as follows.
Please lock the casters when you adjust the screen height. (Refer to page 5.)
1
Loosen the height adjustment handles.
2
Hang the step frame on the reinforce pipe and
lift the board attachment (lower) by stepping on
the step frame.
Slide along the slide groove.
The screen height must be adjusted by two people.
3
Hang the screen in the desired slots of the slide
plates.
Do not use slot 4.
Slot 4 cannot be used for screen height adjustment.
Confirm both sides of the screen are hung in the
same height slots securely.
Slot Adjustment Screen Height
Slot 1 Available 2000 mm
Slot 2 Available 1875 mm
Slot 3 Available 1750 mm
Slot 4 Cannot be used –
Height
adjustment
handles
Height
adjustment
handles
Lift
Slide
groove
Down
Step frame
Board attachment
(lower)
Reinforce pipe
Slot 4
Slot 3
Slot 2
Slot 1