Filter
Top Products
106
q WJ-NT204 DIRECT COAXIAL CAMERA SELECT
Select the input number to the WJ-NT204 from 1 to 4
and AUX.
w WJ-MP204 CAMERA SELECT
When AUX is selected, a 16-button panel appears
where you can select a camera connected to the WJ-
MP204 Data Multiplex Units #1 through #4 while AUX
button disappears. The numbers of buttons will vary
from 16 to 12, 8 or 4 depending on the numbers of the
connected WJ-MP204 units and when the html file is
changed accordingly. To return the panel back to 5-
button, click on any of the input button from 1 to 4 in
the WJ-NT204 DIRECT COAXIAL CAMERA SELECT.
e ALARM LIST (WJ-NT204)
Displays the alarm list activated on the WJ-NT204
transmitter.
r ALARM RESET
Resets the alarm mode activated on the WJ-MP204 or
WJ-NT204 transmitter.
t CAMERA PRESET REGISTRATION
Select the number and click the SET to register the pre-
set position that is presently displayed of the camera
connected to the WJ-NT204 or WJ-MP204. Position
entry is available up to 64.
y PAN/TILT
Click on any of the pan/tilt buttons: Up, Down, Right or
Left to move the pan/tilt head of the Combination cam-
era to the desired direction. Click the button repeatedly
as necessary not holding down it.
u ZOOM
Click the button to zoom in or out. Instead holding
down the button, click on it repeatedly as necessary.
TELE: Zooms in the image.
WIDE: Zooms out the image.
i FOCUS
Click NEAR or FAR to adjust the focus of the image
manually. Instead holding down the button, click on it
repeatedly as necessary.
NEAR: Manual focusing
FAR: Manual focusing
AUTO: The built-in focus mechanism performs in the
Combination camera.
o IRIS
The connected combination camera (option) can be
controlled to close or open the iris by clicking the
[CLOSE] or [OPEN] button under IRIS.
Clicking the [OPEN] or [CLOSE] button will open or
close the camera iris for a specified time, after which
the operation is released automatically.
Clicking the [RESET] button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN] or [CLOSE] button depressed. You need to
click the [OPEN] or [CLOSE] button again.
!0 AUTO PAN
The auto pan status of the connected combination
camera (option) can be changed by clicking the [ON]
or [OFF] button under AUTOPAN.
Note: When LOCAL is selected in the camera setup
menu, auto pan is released automatically within 1
minute.
!1 PRESET
To move the connected combination camera (option) to
any of 64 preset positions and the HOME position.
Select a preset position number, then press the [SET]
button to move the camera to the position.
!2 Status Display
Displays alarm information when an alarm connected to
the WJ-MP204 or WJ-MP204 is activated.
!3 Image Display
The image supplied from the selected camera is dis-
played.
q
w