Filter
Top Products
SNMP MIB Objects
E-6
3166-A2-GB20-10November 1998
Interface Group – Input Counters (objects ifEntry 10 to ifEntry 15)
These objects collect statistics on the data received by the COM port when it is
configured as an SNMP management link. For an interface that is not configured
as an SNMP management link, these statistics are not provided and an error
status is returned if access is attempted. The objects used to collect input
statistics are listed below:
H ifInOctets (ifEntry 10)
H ifInUcastPkts (ifEntry 11)
H ifInNUcastPkts (ifEntry 12)
H ifInDiscards (ifEntry 13)
H ifInErrors (ifEntry 14)
H ifInUnknownProtos (ifEntry 15)
Interface Group – Output Counters (objects ifEntry 16 to ifEntry 21)
These objects collect statistics on the data received by the COM port when it is
configured as an SNMP management link. For an interface that is not configured
as an SNMP management link, these statistics are not provided and an error
status is returned if access is attempted. The objects used to collect output
statistics are listed below:
H ifOutOctets (ifEntry 16)
H ifOutUcastPkts (ifEntry 17)
H ifOutNUcastPkts (ifEntry 18)
H ifOutDiscards (ifEntry 19)
H ifOutErrors (ifEntry 20)
H ifOutQLen (ifEntry 21)
IP Group, MIB II
The IP Group objects are supported by the DSU/CSU for all data paths which
currently are configured to carry IP data to or from the DSU/CSU, including the
COM, carrier SNMP bus, and FDL. All of the objects in the IP Group other than
the IP Address Translation table are fully supported. The IP Address Translation
table (ipNetToMediaTable) does not apply to the DSU/CSU and will be empty
(i.e., have zero entries). The following sections provide clarification for objects
contained in the IP Group when it is not clear how the object definition in MIB II is
related to the DSU/CSU.