Paradyne 3911 Network Card User Manual


 
COMSPHERE 3900 Series Modems
10-6 September 1998 3910-A2-GN32-40
To access Dial Standby or Return to Dial from the Call Setup branch, make the following
selections:
F1
Call Setup:
Dial Standby
F2
F3
Press the key until Dial Standby or Return_to_Dial appears. Select the appropriate function.
F1
Dial Standby
Command Complete
F2
F3
If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem
to primary leased lines and the LCD displays the status message Command Complete.
Once the modem is in Dial Standby mode, Return_to_Dial appears on the LCD. Selecting this
function forces the modem to the backup network and the LCD displays the status message
Command Complete.
Change Directory
Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile
memory locations that allow you to store up to 24 telephone numbers. Each directory location
can accept up to 40 characters; this includes the telephone number and dial command modifiers.
Any telephone number dialed using the DCP Dial command must appear in a directory location.
NOTE
If the modem is operating on leased lines and has a dial line
attached for dial backup purposes, it is required that directory
location 1 contain the telephone number used for dial backup.
To access Change Directory from the Call Setup branch, make the following selections:
F1
Call Setup: <
Change_Directory
F2
F3