Filter
Top Products
AT Command Set and S-Registers
14-213910-A2-GN32-40 September 1998
Table 14-3
(7 of 13)
391x Series S-Registers
S-Register
DCP LCD
Command
Sequence
Description
S61 CT111 Rate Control. Register determines if CT111 Rate is disabled,
set for Fallback 1 or Fallback 2.
CT111 Rate allows the DTE to control modem rate via Pin 23 of the
EIA-232-D interface. This configuration option determines the effect of
the DTE Rate Control signal. It is only valid in Async Direct mode and
Synchronous mode. For proper operation, disable the V.32bis Autorate
and V.32bis Automode configuration options.
Register has the following values:
0 = Disable
1 = Fallback
2 = Fallback 2
The factory setting is Disable.
Configure\Edit\
DTE Interface
S62 V.25bis Coding. Register identifies to the modem the type of coding
used by the DTE while in V.25bis mode.
Register has the following values:
0 = ASCII
1 = EBCDIC
The factory setting is ASCII.
Configure\Edit\
DTE Dialer
S63 V.25bis Idle Character. Register identifies to the modem the type of
idle fill used by the DTE while in V.25bis mode.
Register has the following values:
0 = Mark
1 = Flag
The factory setting is Mark.
Configure\Edit\
DTE Dialer
S64 V.25bis New Line Character. Register identifies to the modem the type
of line terminator used by the DTE while in V.25bis mode.
Register has the following values:
0 =Carriage Return and Line Feed
1 =Carriage Return
2 =Line Feed
The factory setting is carriage return and line feed (CR + LF).
Configure\Edit\
DTE Dialer
S65 Line Current Disconnect. Register determines if the modem
disconnects if an 8-millisecond or 90-millisecond interruption in loop
current occurs.
Register has the following values:
0 = Enable (8msec)
1 = Enable (90msec)
2 = Disable
The factory setting is Enable (8msec).
Configure\Edit\
Line Dialer