Filter
Top Products
Checklist for Setting Up SNMP Features
B-2
8000-A2-GB20-20November 1997
Management System Source Validation for DSL cards
From the DSL Main Menu, select
Configuration
→
SNMP
→
Security
(A-F-A).
- Enable IP address security validation.
- Enter the IP addresses of up to five NMS managers that will permitted access
to this DSL card.
Each card does not have to have the same set of managers as any other
card or as the MCC.
- Enter access permission to be granted each NMS system
(ReadOnly(ro)/Read/Write(rw)/NoAccess(na)).
DSL SNMP Community Strings and Authentication Failure Trap
From the DSL Main Menu, select
Configuration
→
SNMP
→
Communities/Traps
(A-F-C).
- Enter Read Only community string name(s).
- Enter Read/Write community string name(s).
- If desired, enable the Authentication Failure trap.
Enable DSL Port Traps
From the DSL Main Menu, select
Configuration
→
Ports
→
DSL Ports
(A-B-B).
- Select a DSL port.
- If desired, enter a value for the Margin Threshold.
- If desired, enter a value for the Link Down Count Threshold.
- If desired, enter a value for the Error Rate (minute) Threshold.
- If desired, enter a value for the Error Rate (hour) Threshold.
- Reset the port (A-C-C).
Enable/Disable Endpoint Security to 5446 RTU
From the DSL Main Menu, select
Configuration
→
SNMP
→
Security
(A-F-A).
- Select an endpoint cookie.
- Enable/Disable endpoint security for the specified port.