Filter
Top Products
17
Configuring SNMP Trap Managers and Traps
Procedure
To enter SNMP managers and configure traps:
1.
Select SNMP Traps.
Main Menu
→
Configuration
→
Management and Communication
→
SNMP Traps
2.
Configure the following:
— Enable SNMP Traps.
— Identify the total Number of Trap Managers.
— Specify the IP address for each NMS Trap Manager to which traps will be sent.
— Specify the Initial Route Destination for each Trap Manager. The default is
AutoRoute.
— Select or disable trap categories, as needed.
3.
S
ave the configuration.
Setting Up for In-Band Management
If FRF.8 Encapsulation Mode is set to Translational, remote management of the router
can still be accomplished in-band, as indicated in the following procedure.
The following procedure assumes that the router’s Ethernet interface has already been
assigned an IP address that is in the same subnet as the management IP address
entered in Step 6 on page 16 of
Using the Easy Install Feature
, and that the router is not
configured for bridging only.
Refer to
Configuring the FrameSaver DSL Router
;
CLI Commands, Codes, and
Designations
, and
Command Line Summaries and Shortcuts
in the User’s Guide for
additional information.