Filter
Top Products
9
5.
Insert the supplied power cord’s round end into the jack labeled POWER. Plug the
transformer into an AC outlet.
Install the supplied tie wrap for strain relief, as shown.
Installation of the hardware is now complete. When the power cord is installed, the
router goes through a power-on self-test.
Power-On
When power is applied, the router performs self-diagnostics and the PWR LED is on.
The self-diagnostics include a power-on self-test where all of the LEDs are on.
Refer to
Status LEDs
on page 10 for information about the LEDs. Refer to
Troubleshooting
on page 11 for LED indications requiring action.
OK
OK
ALM
TEST
AT M
DSL
NetworkSystem
Port
9783-C
SLV
FrameSaver
®
DSL
SDSL
R
01-16877-01
ETHERNET
COM
POW
ER
NET
Grounded
Power
Outlet
Tie
Wrap
Power
Jack
OK
OK
ALM
TEST
AT M
DSL
NetworkSystem
Port
9783
ROUTER
FrameSaver
TM
SLV
FrameSaver
®
DSL
SDSL
R
01-16857-01
OK
OK
ALM
TEST
AT M
DSL
NetworkSystem
Port
9783
ROUTER
SLV
FrameSaver
®
DSL
SDSL
R
System OK – green
Alarm – red
Test – yellow
ATM – green/yellow
DSL – green
Ethernet Port – green