Filter
Top Products
9
Model 2977 DialFire RAS User Guide
Compliance Information
FCC Part 68 Compliance Statement
This equipment complies with Part 68 of FCC Rules. Please note the following:
1.
You are required to request service from the telephone company before you connect the RAS to a network.
When you request T1 Service, you must provide the telephone company with the Facility Interface Code.
Provide the telephone company with the appropriate FIC codes from Table 1 on page 8 for the DialFire
B4/ST, Table 2 on page 8 for the DialFire B4/U, or Table 3 on page 8 for the DialFire 24/48 Dual-T1.
The telephone company will select the code it has available. The Service Order Code(s) (SOC): 6.0P. The
required Universal Service Order Code (USOC) jack: RJ49C. The make, model number, and FCC Regis-
tration number of the RAS.
2.
Your telephone company may make changes to its facilities, equipment, operations, or procedures that
could affect the proper functioning of your equipment. The telephone company will notify you in advance
of such changes to give you and opportunity to maintain uninterrupted telephone service.
3.
If your RAS causes harm to the telephone network, the telephone company may temporarily discontinue
your service. If possible, they will notify you in advance, but if advance notice is not practical, you will be
notified as soon as possible and will be informed of your right to file a complaint with the FCC.
4.
If you experience trouble with the RAS, please contact Patton Electronics, Co. for service or repairs.
Repairs should be performed only by Patton Electronics Co.
5.
You are required to notify the telephone company when you disconnect the RAS from the network.
CE Notice
The CE symbol on your Patton Electronics equipment indicates that it is in compliance with the Electromag-
netic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the European Union (EU). A
Certificate of Compliance is available by contacting Technical Support.