Filter
Top Products
24
The following commands conÞgure the error monitor:
• dsl set errmon maxint <maxint>: Sets the number of errors allowed
in an interval causes it to be considered an errored interval. If this is
set to ‘0’, then the error monitor is disabled.
• dsl set errmon inttime <inttime>: Sets the length of each interval.
• dsl set errmon intcnt <intcnt>: Sets the number of errored intervals
that causes the DSL link to restart.
• dsl set errmon totint <totint>: Sets the number of intervals to inspect
for errors before disabling the error monitor. If this is set to ‘0’, then the
error monitor will run continuously.
• dsl set errmon startdelay <startdelay>: Sets the number of seconds
to wait after the DSL link comes up before the error monitor starts
inspecting intervals.
Changing the data rate (dsl set timeslots), the clock mode (system set
clockmode), the Annex (dsl set annex), or Line Probe (dsl set
lineprobe), or the DSL error monitor settings will not take effect on the
DSL link until the link restarts. The dsl start command restarts the
DSL link.
DSL Status Command
The dsl show status command shows the following DSL status informa-
tion: link state, sync state, link speed, error counters, line condition, noise
margin, and test mode status.
DSL Clear Errcntrs Command
The dsl clear errcntrs command clears the error counters.