Filter
Top Products
Viewing G.SHDSL Status 30
Model 3231 User Manual 3 • G.SHDSL Configuration and Status
The following shows the relationship of the DSL Error Monitor parameters:
The DSL error monitor inspects intervals to see if they have met the error threshold (Max Interval Errors). If
the error monitor finds a certain number (Interval Count) of intervals that meet or exceed the error threshold,
it will restart the DSL link. The error monitor will wait (Start Up Delay) seconds after the DSL link comes up
before it begins monitoring errors. After the startup delay, it will check the number of errors that have occurred
during each (Interval Time) seconds to see if they meet the error threshold. The error monitor inspects (Total
Intervals) intervals before it stops.
Note
Setting Max Interval Errors to 0 disables the error monitor and setting
Total Intervals to 0 causes the error monitor to run continuously.
The following commands configure the error monitor:
• Error Monitor Max Interval Errors: Sets the number of errors allowed in an interval causes it to be consid-
ered an errored interval. If this is set to 0, then the error monitor is disabled.
• Error Monitor Interval Time (sec): Sets the length of each interval.
• Error Monitor Interval Count: Sets the number of errored intervals that causes the DSL link to restart.
• Error Monitor Total Intervals: Sets the number of intervals to inspect for errors before disabling the error
monitor. If this is set to 0, then the error monitor will run continuously.
• Error Monitor Start Up Delay: Sets the number of seconds to wait after the DSL link comes up before the
error monitor starts inspecting intervals.
Viewing G.SHDSL Status
You can view the status of the G.SHDSL link through the Web GUI. (See “Connecting to the Web GUI” on
page 26). Selecting the Status hyperlink on the Configuration Menu provides the web page containing the
G.SHDSL status and the Bridged PPP link status. The G.SHDSL Status is divided into three groups, Run-
Time Statistics, DSL Line Error Counters, and Local Interface Error Counters.
Note
It is NOT reccommended that you configure G.SHDSL through the Web
GUI. Use the LCD panel menu to configure G.SHDSL options, and use the
Web GUI for advanced status monitoring only.
Startup Delay Interval #1 Interval #2 …
Interval #Total
Intervals
ÕStart Up DelayÖ ÕInterval Time (sec)Ö ÕInterval Time (sec)Ö ÕInterval Time (sec)Ö ÕInterval Time (sec)Ö