Patton electronic 3241 Modem User Manual


 
3 • Quick Start Installation Model 3201 G.SHDSL Integrated Access Device User Guide
24 Hardware installation
Router/Bridge Status LEDs
The LEDs indicate the status of power, the WAN (DSL) inter-modem link, and the Ethernet connection.
Note When extinguished, the LED indicators are clear; when lit, they shine
a brilliant yellow.
Web Operation and Configuration
Now that the IP address has been configured for your application, you can complete the configuration using
any standard web browser.
PC Configuration
In order to connect the PC to the Ethernet LAN to communicate with the Model 3201, the PC’s IP address
should be on the same subnet as the modem.
Connect a straight-through Ethernet cable between the PC’s NIC or PCMCIA Ethernet card and an Ethernet
hub or switch.
Web Browser
Do the following:
1. Launch a standard web browser such as Netscape Communicator or Internet Explorer (IE).
2. Enter the 3201’s IP address into the URL or Address field of the browser.
Power Yellow
ON
indicates that power is applied.
off
indicates that no power is applied.
2 Hz flash
occurs during POST
1 Hz flash
occurs for non-fatal error.
8 Hz flash
on all LEDs for fatal POST outcome or critical error.
WAN
(DSL)
Link Yellow
Solid yellow:
connected
2 Hz flash:
training
8 Hz flash:
DSL error
No indication:
no signal detected.
TX Yellow
Flashing:
when transmitting data from the unit to the WAN.
RX Yellow
Flashing:
when receiving data from the WAN to the unit.
Ethernet Link Yellow
On:
Ethernet is linked.
100M Yellow
On:
100 Mbps Ethernet is selected.
TX Yellow
Flashing:
when data is transmitted from the unit to the LAN.
RX Yellow
Flashing:
when data is received from the LAN.