Filter
Top Products
A-2 Telnet Console Commands
5. To view the current wireless settings, type sh en (show wireless
settings)
and press Enter:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ABC1234
Speed = 11
AP density = LOW
WEP is DISABLED
AP MAC ADDRESS = 00 B1 F3 62 B1 88
Signal Quality = 68
Connected to SSID ABC1234 on channel 1
6. To show the current IP settings, type sh ip (show TCP/IP settings) and
press Enter.
IP is enabled
IP address 10.5.192.192 Boot tries 3
Subnet mask 255.255.0.0 Boot method DHCP
IP Gateway 10.5.156.254 Max window 10240
(via DHCP 10.62.5.10)
LPD banner disabled Timeout 0 min
LPD retries are disabled Keepalive 1 min
7. To change the SSID, type set en ssid testsystem and press Enter.
8. To set the IP address, type set ip ad 10.10.302.192 and press
Enter.
9. To set the subnet mask, type set ip sub 255.255.255.0 and press
Enter.
10. Type INIT and press Enter to save the settings and initialize the unit.
11. Type Exit to exit Telnet.
See the following tables for a list of the most frequently used commands.