Filter
Top Products
45
Line Commands
Set Line Service
echo-suppression
This parameter applies only to EIA-485 Half Duplex mode. All characters will be
echoed to the user and transmitted across the serial ports. Some EIA-485 applications
require local echo to be enabled in order to monitor the loopback data to determine that
line contention has occurred. If your application cannot handle loopback data, echo
suppression should be
On. The default is echo suppression Off.
speed
Specifies the baud rate of the line; keep in mind that speed is affected by the length of
the cable. You can also specify a custom baud rate; valid values are 50 - 1843200.
Description Sets the service for the line. For services that need further configuration, see Line
Service Commands on page 48 to find the Line Service that you want to configure.
User Level Admin
Syntax
set line .|<number>|* service bidir <config_host> <server_port>
<host_port>
set line .|<number>|* service direct raw <config_host>
<host_port>
set line .|<number>|* service silent raw <config_host>
<host_port>
[multihost all|backup <config_backup_host> <host_port>|none]
set line .|<number>|* service direct|silent telnet <config_host>
[<host_port>]
set line .|<number>|* service reverse raw [multihost
on|off]|telnet <server_port>
set line .|<number>|* service client-tunnel <config_host>
<host_port>
set line .|<number>|* service server-tunnel <server_port>
set line .|<number>|* service dslogin|udp|vmodem|modbus-master|
modbus-slave|custom-app
set line .|<number>|* service trueport client-initiated off
<config_host> <host_port> [signal-active on|off]
[multihost all|backup <config_backup_host> <host_port>|none]
set line .|<number>|* service trueport client-initiated on
<server_port> [signal-active on|off] [multihost on|off]
Options bidir
This service allows the IOLAN to listen for incoming TCP connection and if needed,
initiate a TCP connection.
<config_host>
The name of the target host. The host must exist in the IOLAN host table.
<server_port>
The IOLAN port number.