Filter
Top Products
IPsec Commands
112 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Show RIP Peers
IPsec Commands
Once there is an active VPN tunnel, the IOLAN expects all connections to be established through a
VPN tunnel. To allows hosts to connect outside of the VPN tunnel, you must configure VPN
exceptions, see
VPN Exceptions on page 119 for the command syntax.
Add IPsec
Set IPsec
Description Shows current information about IPv4 or IPv6 RIP peers.
User Level Normal, Admin
Syntax
show rip peers [ipv6]
Description Adds an IPsec tunnel.
User Level Admin
Syntax
add ipsec <tunnel_name>
Option <tunnel_name>
The name of an IPsec VPN tunnel. You can configure up to 64 VPN tunnels.
Description Configures the IPsec tunnel.
User Level Admin
Syntax
set ipsec <config_tunnel_name>
[authentication-method shared-secret|rsa-signature|x.509-certificate]
[boot-action start|add|ignore] [local-device left|right]
[
local-external-ip-address <IPv4/IPv6_address/FQDN>]
[local-host-network <IPv4_addr> <subnet_mask>|
<IPv6_address> <prefix_bits>
]
[local-ip-address <
IPv4/IPv6_address/FQDN>]
[local-next-hop <IPv4/IPv6_address>]
[remote-external-ip-address <IPv4/IPv6_address/FQDN>]
[remote-host-network
<IPv4_addr> <subnet_mask>|
<IPv6_address> <prefix_bits>
]
[remote-ip-address <IPv4/IPv6_address/FQDN>]
[remote-next-hop <
IPv4/IPv6_address>]
[remote-validation-criteria
country <code>|state-province <text>|locality <text>
|organisation <text>|organisation-unit <text>
|common-name <text>|email <email_addr>]
set ipsec <config_tunnel_name> secret <text>
set ipsec use-nat-traversal enabled|disabled