Filter
Top Products
Set IOChannel
148 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Set IOChannel IOExtension
clear-mode
Specifies whether an activated alarm must be Manually cleared, or can be cleared when
the input drops below the specified value (when
Trigger Type is High) or goes above
the specified value (when
Trigger Type is Low).
clear-level
Specify that value that will clear an alarm, the measurement is based on the Type and
Range that you specify. This value must not fall within the scope of the value used to
trigger an alarm.
email
Sends an email alert to an email account(s) set up in the Server settings (the Line Email
Alert
settings are not used with this feature) when an alarm is triggered or cleared. The
email alert data includes the severity level and the value that caused the alarm to trigger
or clear. The Email Alert is associated with
Level Critical.
snmp
Sends an SNMP trap when an alarm is triggered or cleared. The trap consists of the
severity level and whether the alarm was triggered or cleared.
syslog
Sends a message to syslog when an alarm is triggered or cleared. The syslog entry
includes the severity level and the value that caused the alarm to trigger or clear. The
syslog message is associated with
Level Critical.
Description Configures the I/O extension options that allow you to connect the Digital Input
channel or input serial signal pin (when the line is configured for signal-io) to Digital
Output/Relay channels or output serial signal pins (when the line is configured for
signal-io) on the same IOLAN, remote IOLAN(s), and/or TCP/IP applications running
on local hosts.
User Level Admin
Syntax
set iochannel <channel> ioextension enabled on|off
[keepalive on|off]
set iochannel <channel> ioextension connection-method
client-initiated [tcp-port <tcp_port>] [multihost on|off]
set iochannel <channel> ioextension connection-method
server-initiated <host_name> [tcp-port <tcp_port>]
[multihost all|backup <config_backup_host> <host_port>|none]
set iochannel <channel> ioextension connection-method
local-connection [<input_channel>]
Options <channel>
Specify the Digital/Relay channel or serial signal pin that you are configuring the I/O
extension for. The channel can be d1, d2, d3, d4, r1, r2, depending on the model. The
serial signal pins are dsr, dcd, or cts for input and dtr or rts for output.