Filter
Top Products
User Commands 65
Configuring Users
netmask
This is used for the PPP or SLIP Service types. Only used for IPv4. If the remote user
is on a subnet, enter the network’s subnet mask. For example, a subnet mask of
255.255.0.0.
password
The password the user will need to enter to login to the IOLAN. This case-sensitive
field accepts a maximum of 16 characters.
line-access
Specifies the user access rights to each IOLAN device line. Options are:
z Read/Write—Users are given read and write access to the line.
z Read In—Users are given access to read only outbound data, data that is going
from the IOLAN to the device.
z Read Out—Users are given access to read only inbound data, data that is going
from the device to the IOLAN.
Users can read data going in both directions by selecting both the
Read In and Read
Out options. The on|off option is only for 1-port models. You can disable line access
in 2-port + models by specifying
0 (zero).
phone-number
The phone number the IOLAN will dial to callback the user (you must have set
Callback to On). Enter the number without spaces. To change the phone number,
overwrite the previous entry; to clear the phone number, set it to
"" (double quotes
without a space).
routing
Determines the routing mode used for RIP packets on the PPP and SLIP interfaces for
this user. Values are:
z None—RIP packets are neither received nor sent by the IOLAN.
z Send—RIP packets can only be sent by the IOLAN.
z Listen—RIP packets can only be received by the IOLAN.
z Send and Listen—RIP packets are sent and received by the IOLAN.
service
The type of service that the user will use.
sess-timer
The amount of time, in seconds, that the Session Timer will run. Use this timer to
forcibly close a user’s session (connection). When the
Session Timer expires, the
IOLAN will end the connection. The default value is
0 (zero), meaning that the session
timer will not expire (the session is open permanently, or until the user logs out). The
maximum value is 4294967
seconds. The User Session Timer will override the Line
Session Timer, with the exception of reverse SSH or reverse Telnet sessions.
port
.For outbound User Services such as Telnet, SSH, TCP clear or SSL raw, this is the
target port number. The default value will change based on the type of Service selected;
the most common known port numbers are used as the default values.
access-clustered-ports
When enabled, allows the user access to IOLANs that have been configured in the
clustering group. The default is on.