Filter
Top Products
Line Commands
72 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Set Line Interface
The SCS and STS IOLAN models only support the EIA-232 interface and therefore does not require
the
interface parameter, instead you can just set the parameters for the EIA-232 interface.
Description Configures line interface (hardware) parameters.
User Level Admin
Syntax
set line .|<number>|* interface eia-232 [monitor-dcd on|off]
[monitor-dsr on|off] [flow none|soft|hard|both]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|
19200|38400|57600|115200|230400|28800|custom <baud_rate>]
set line .|<number>|* interface eia-422
[flow none|soft|hard|both]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800|
custom <baud_rate>]]
set line .|<number>|* interface eia-485-half-duplex
[tx-driver-control auto|rts] [flow none|soft]
[echo-suppression on|off]]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800|custom <baud_rate>]
set line .|<number>|* interface eia-485-full-duplex
[tx-driver-control auto|rts] [flow none|soft]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800|custom <baud_rate>]
Options eia-232 | eia-422 | eia-485-half-duplex|eia-485-full-duplex
Specifies the type of serial line that is being used with the IOLAN. Specify either
EIA-232, EIA-422, EIA-485-half-duplex, or EIA-485-full-duplex. The STS and SCS
models support only EIA-232.
monitor-dcd
Specifies whether the RS-232 signal DCD (Data Carrier Detect) should be monitored.
This is used with modems or any other device that sends a DCD signal. When it is
monitored and the IOLAN detects a DCD signal, the line service is started. Default is
Off. If both Monitor DCD and Monitor DSR are enabled, both signals must be detected
before the line service is started.
monitor-dsr
Specifies whether the RS-232 signal DSR (data set ready) should be monitored. This is
used with modems or any device that sends a DSR signal. When it is monitored and the
IOLAN detects a DSR signal, the line service is started. Default is
Off. If both Monitor
DCD and Monitor DSR are enabled, both signals must be detected before the line
service is started.
flow
Defines whether the data flow is handled by the software (Soft), hardware (Hard),
Both, or None. If you are using SLIP, set to Hard only. If you are using PPP, set to
either
Soft or Hard (Hard is recommended). If you select Soft with PPP, you must set
the
ACCM parameter when you configure PPP for the Line.
tx-driver-control
Used with a EIA-485 serial interface, if your application supports RTS (Request To
Send), select this option. Otherwise, select
Auto. Default is Auto.