Filter
Top Products
User Manual BDL3215E / BDL4225E
16
Install the LCD Monitor in Portrait Mode
BDL3215E/BDL4225E can be installed in portrait position, under the following conditions:
Caution:
Portrait mode is effective only when wall-mounted or ceiling-mounted. The table stand can not be used for the monitor in portrait position.
Placing the monitor in portrait position, will shorten the average life of the LCD backlight.
Operational Environment (Temperature) shall be limited, as shown below:
Operational
Environment
Temperature 5 - 35 °C / 41 - 95 °F
Humidity 20 - 80 % (Without condensation)
Please orientate the monitor in the direction shown as the right figure:
Do not place monitor in landscape in any other manner.
How to set-up
Remove the table stand if they are attached.1.
The “ 2.
” logo should be on the LEFT side when facing the monitor.
90
90
How to Remove the Logo for landscape mode?
Prepare a piece of paper with a cutting area of logo as a protector to prevent the front bezel from scratching.1.
Using a knife, carefully remove the logo sticker with the paper placing beneath.2.
Tear off the logo sticker.3.
1
2
3
How to Use the Logo Guider for Portrait Mode?
(a) Before applying, make sure the guider is well shaped. The “PHILIPS” sticker attached on the end of it could be folded back as figure (a).
(b) Turn back the logo end of the guider and remove the sticky tape of the logo.
(c) Slide the logo guider along the short side of the front bezel as figure c & then return the logo end of the guider back to the right side.
(d) With your left hand fixing the guider, scrunch the logo by your right hand to make it stuck firmly on the front bezel.
(e) Remove the guider and leave the logo over the front bezel.
Clockwise Counterclockwise