Filter
Top Products
Chapter 3
3-16
SuperIO Device
Press Enter to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Enable the onboard floppy controller. Select
Enabled when you have
installed a floppy disk drive. Settings:
Enabled, Disabled
Onboard Serial Port 1/2
Set the base I/O port address and IRQ for the onboard serial port A/serial
port B. Selecting
Auto allows BIOS to automatically determine the
correct base I/O port address. Settings:
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port.
Settings:
Disabled, 378/IRQ7, 278/IRQ5, 3BC/IRQ7
Parallel Port Mode
Set the parallel port mode. To operate the onboard parallel port as
Standard Parallel Port, choose
SPP. To operate the onboard parallel port
in the EPP mode, choose
EPP. By choosing ECP, the onboard parallel port
will operate in ECP mode. Choosing
ECP + EPP will allow the onboard
parallel port to support both the ECP and EPP modes simultaneously.
Settings:
SPP, EPP, ECP, ECP + EPP
Port Settings
1
Disabled 3F8/IRQ4 2F8/IRQ3 3E8/IRQ4 2E8/IRQ3 Auto
2
Disabled 3F8/IRQ4 2F8/IRQ3 3E8/IRQ4 2E8/IRQ3 Auto