Filter
Top Products
9
The Windows Hardware Wizard will assign the iPort DLL/USB to a new
communications port number. You can find the ComPort number of the iPort
DLL/USB by running our Message Center or Message Manager software, and
selecting the iPort DLL/USB device. You can also find the ComPort number
by expanding the Ports Icon in the Windows Control Panel | System | Device
Manager application.
At this time you can install the iPort Utility Pack software. See the installation
instructions in “Part 2 - iPort Utility Pack for Windows” of this User’s Guide.
2. Connect the I
2
C Bus cable to the I
2
C adapter and your I
2
C device. You can
make this connection with the included I
2
C Clip-Lead cable or I
2
C Interface
Cable.
The I
2
C interconnect includes a +5V wire. You may not need to, or want to,
connect the +5V wire to your target system. Refer to the “+5VDC Power
Jack” and “Hardware Configuration” sections for details on pull-up resistors
and connecting the optional +5V wire.
3. Optionally connect the external power supply to the power jack. I
2
C adapter
power is derived from the USB, with a limited amount of power available to
the target system via the I
2
C connector. Use of the external power supply
provides additional power to the target system via the I
2
C connector. See
“+5VDC Power Jack” section for additional details.
If you have any questions on I
2
C adapter setup and configuration, please contact our
technical support department via our web site.