Filter
Top Products
23
4.2 Command Line Arguments
The Message Center can be controlled via command line arguments. This feature
allows the Message Center to be accessed from a batch file or another program.
Message Center
Command Line Arguments
Command Description
iPort, iPort/AI, iPort/AFM, Variable,
iPort/USB, iPortDLL/USB
Specify I
2
C adapter type.*
COM1...COM20 Specify RS-232 communication port.
BAUD19200, BAUD57600, BAUD115200 Set RS-232 Baud Rate.*
CLOCK12.5K, CLOCK23K, CLOCK86K,
CLOCK100K, CLOCK400K, VCLOCK
Set I
2
C Bus Clock Rate.*
Monitor/INT Enable /INT Signal Monitor.*
StopOnBusy Stop sending on I
2
C adapter busy.
StopOnArbLoss Stop sending on I
2
C Bus Arbitration Loss.
StopOnNak Stop on Slave Negative Acknowledgment.
BeepOnBusy Beep on I
2
C adapter busy.
BeepOnArbLoss Beep on I
2
C Bus arbitration loss.
BeepOnNak Beep on Slave Negative Acknowledgment.
BeepOn/INT Beep on /INT signal assert (low).*
AutoLoad Load I
2
C message list file.
AutoSave Save I
2
C message list file.
AutoOpen Open link to I
2
C adapter.
AutoSend Send I
2
C message list.
AutoExit Exit after sending message list.
* Adapter specific commands. See command details below.
Command Line Syntax: imsgctr.exe AdapterType argument-list
Example: imsgctr.exe iPort/AFM adctest01.iml AutoOpen AutoSend AutoExit