Filter
Top Products
Introduction to your PPS 2 - 9
• ABORt
This subsystem is used for stoppin
g
the step function of the power supply.
• CALibration
This subsystem is used for calibration of the instrument. Your power supply
can be calibrated without removin
g
the cover or removin
g
the power supply
from your rack measurement setup. This feature allows you to calibrate the
power supply at its normal operatin
g
temperature. The recommended
calibration interval is one year. Refer to the Reference Manual for complete
calibration details.
• DISPlay
This subsystem is used to control the front panel display.
• INITiate
This subsytem is used to start up (initiate) the step function of the power
supply.
• INSTrument
This subsystem is used to control the instrument functions.
• MEASure
This subsystem is used to measure (readback) output volta
g
e and output
current.
• OUTPut
This subsystem is used to control an output channel.
• SOURce
This subsystem is used for source and settin
g
functions of an output channel,
such as : - source definitions
- volta
g
e (protection) settin
g
s
- current (protection) settin
g
s
- automatic steppin
g
• STATus
This subsystem is used for handlin
g
the device-dependent operational and
questionable status information.
• SYSTem
This subsystem is used to handle system and control functions, such as:
- lockout front panel control
- define the ’power on clear’ behavior
- request for status information
• TEST
This subsystem is used to test the instrument.