Filter
Top Products
18
En
System Settings
English
System Settings
Settings after connections
After components have been connected to INPUT1 or
INPUT2, on-screen setup is necessary.
Follow the procedure described below and make settings
as they apply to the type of components connected.
[SIGNAL FORMAT] setup
3 Use the 5/∞ buttons to select [SIGNAL FORMAT],
then press the SET button.
MENU INPUT1
CHANGE
SET
EXIT
MENU
SCREEN SETUP OPTION
POWER MGT. :OFF
SIGNAL FORMAT
PICTURE
4 Use the 2/3 buttons to select the input signal.
:
SIGNAL FORMAT
AUTO
SET
SET
EXIT
MENU
Each time the 2/3 buttons are pressed, the selection
alternates as follows:
÷ AUTO .... Signals are detected automatically in
accordance with the Computer signal
compatibility table (pages 42 to 44)
÷ Others ... Selectable resolutions are displayed.
5 Press the SET button.
The setting is stored in memory and the screen
returns to that shown in step 3.
6 When the setup is completed, press the MENU
button to exit the menu screen.
Note
Make [SIGNAL FORMAT] setting for each input (INPUT1 and
INPUT2).
MENU
5/∞
SET
2/3
1 Press the MENU button to display the menu
screen.
SCREEN SETUP OPTION
:
0
:
0
:
0
CONTRAST
:
0
BRIGHTNESS
H.ENHANCE
V.ENHANCE
PICTURE RESET
PICTURE
MENU INPUT1
ENTER
SET
EXIT
MENU
2 Use the 2/3 buttons to select [SETUP].
MENU INPUT1
SCREEN SETUP OPTION
POWER MGT. :OFF
SIGNAL FORMAT
PICTURE
STANDBY/ON MENU
DISPLAY
/ SET
– VOL +INPUT SCREEN SIZE
2/3MENU SET 5/∞
Remote control unit
Main unit operating panel
3 AUTO
Others 2