Filter
Top Products
11
EX2 Display Controller
QUICK LINKS
Contents
Index
Regulatory Compliance
Warranty
GETTING STARTED
About the Display Controller
Check Package Contents
INSTALLING THE BOARD
Check System Requirements
Install Controller
Connect Cables
INSTALLING THE DRIVER
Install Display Driver
Adjust Display Properties
APPENDIXES
Troubleshooting
Specifications
Video Modes
Driver Removal
Gallery
Address and interrupt conflicts Ensure that the I/O and memory addresses reserved for the controller are not used by
other hardware devices.
The integrated onboard VGA controller uses the following addresses (hex):
I/O Addresses:
Standard VGA I/O: 3B0-3Df
Memory Addresses:
Video RAM: A000-BFFF
Video ROM: C000-C7FF
You cannot change the addresses of the EX2 controller. In case of an address conflict,
try to modify the I/O address of the add-on card that causes the conflict.
To support the special graphics processor on the controller, the system BIOS should
automatically assign a system interrupt to the AGP slot where the controller is installed.
There may be problems if your controller does not receive an interrupt or if a system interrupt
is used for more than one device.
Check the system configuration utility of your operating system for the interrupt assignments.
Problem Possible Solution