Filter
Top Products
PPPoE / PPPoA Mode
Select this option if your ISP requires you to use a PPPoE / PPPoA connection. This option
is typically used for DSL service. Please enter the proper information in the fields.
1. Open the WEB page at “WAN Æ WAN Interface”.
2. Select the Channel Mode to “PPPoE”. Set the value of VPI / VCI and select the
Encapsulation mode from your ISP.
3. Enter the User Name / Password from your ISP.
4. Select the PPP connection type: Continuous, Connect on demand and Manual. If
you select “Connect on demand” type, specify how many minutes the connection
may be idle before it disconnects. If you select “Manual” type, use “Connect”
and ”Disconnect” buttons to start / stop PPP connection.
5. Click “Add” button to add this channel. You can use the “Modify” and “Delete”
button to manage your PVC.
6. Go to “Admin Æ Commit/Reboot” menu, clink “Commit and Reboot” button.
The device will reboot and apply this setting.
Your ISP should provide the above information. Note that you must enter the user name
exactly as your ISP assigned it. If the assigned name is in the form of user@domain where
domain identifies a service name, enter it exactly as given.
MER Mode
Select this option to set static IP information. You will need to enter in the encapsulation type,
IP address, subnet mask, and gateway address provided to you by your ISP. Each IP
address entered in the fields must be in the appropriate IP form, which is 4 IP octets
separated by a dot (x.x.x.x). The Router will not accept the IP address if it is not in this
format.
37