Filter
Top Products
Installation
9
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the ADE-
4300/ADW-4300. Both 10BaseT and 100BaseT connections can be used simulta-
neously.
If required, connect any port to a normal port on another Hub, using a standard
LAN cable. Any LAN port on the ADE-4300/ADW-4300 will automatically function
as an "Uplink" port when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADE-4300/ADW-
4300 (the RJ11 connector) to the ADSL terminator provided by your phone com-
pany.
4. Power Up
Connect the supplied power adapter to the ADE-4300/ADW-4300. Use only the
power adapter provided. Using a different one may cause hardware damage.
Power it up by pressing the rear-mounted power switch.
5. Check the LEDs
· The Power LED should be ON.
· The Status LED should flash, then turn Off. If it stays on or blinking after 60 sec-
onds, there is a hardware error.
· For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the
PC is also ON.)
· The WLAN LED should be ON. (ADW-4300 only)
· The WAN LED should be ON if ADSL line is connected.
· The Internet LED may be OFF. After configuration, it should come ON.
For more information, refer to Front-mounted LEDs in Chapter 1.