Filter
Top Products
ADE-4300/ADW-4300 User Guide
38
Wireless Station Configuration (ADW-4300 only)
This section applies to all Wireless stations wishing to use the ADW-4300's Access
Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the ADW-4300, each Wireless Station must have
compatible settings, as follows:
Mode
The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
SSID (ESSID)
This must match the value used on the ADW-4300. The default
value is Wireless.
Note! The SSID is case sensitive.
Wireless
Security
By default, Wireless security on the ADW-4300 is disabled.
· If Wireless security remains disabled on the ADW-4300, all
stations must have wireless security disabled.
· If Wireless security is enabled on the Wireless Router (either
WEP or WPA-PSK), each station must use the same settings
as the ADW-4300.
Wireless Configuration on Windows XP (ADW-4300 only)
If using Windows XP to configure the Wireless interface on your PC, the configuration
procedure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections).
Figure 28: Network Connections (Windows XP)
2. Right-click the Wireless Network Connection, check that it is enabled (menu option
says Disable, rather than Enable) and then select View Available Wireless Net-
works.
3. You will then see a list of wireless networks.