Filter
Top Products
ADE-4300/ADW-4300 User Guide
84
NETBIOS Enable
Check this if you wish NETBIOS traffic to be forwarded over the
VPN tunnel. The NETBIOS protocol is used by Microsoft
Networking.
Local LAN
Local LAN
This identifies which PCs on your LAN are covered by this
policy. For each selection, data must be provided as follows:
· Single address
Enter an IP address in the "IP address" field. Typically, this
setting is used when you wish to make a single Server on
your LAN available to remote users.
· Subnet address
Enter an IP address in the "IP address" field, and the de-
sired network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses
entered as its "Remote" addresses.
Remote LAN
Remote LAN
This identifies which PCs on the remote LAN are covered by
this policy. For each selection, data must be provided as fol-
lows:
· Single PC - no subnet
Select this option if there is no LAN (only a single PC) at
the remote endpoint. If this option is selected, no additional
data is required.
· Single address
Enter an IP address in the "IP address" field. This must be
an address on the remote LAN. Typically, this setting is
used when you wish to access a server on the remote LAN.
· Subnet address
Enter an IP address in the "IP address" field, and the de-
sired network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses
entered as its "Local" addresses.
ESP Configuration
SPI
Enter the required SPIs. Each policy must have unique SPIs.
These settings must match the remote VPN endpoint. Note that
the "in" setting here must match the "out" setting on the remote
VPN endpoint, and the "out" setting here must match the "in"
setting on the remote VPN endpoint.
Encryption
Select the desired Encryption Algorithm, and enter the key in
the field provided.
· For DES, the key should be 8 ASCII characters (16 Hex
characters).
· For 3DES, the key should be 24 ASCII characters (48 Hex
characters).