7.4.3 TCP/IP
If you need the MFP Server to automatically get an IP from DHCP server, select “Enable
Obtain TCP/IP Settings Automatically (Use DHCP/ BOOTP)”. You also can select “Disable
Use the following TCP/IP Settings” to manually assign “IP Address”, “Subnet Mask” and
“Gateway” for the MFP Server.
IP Address:
IP address is a unique number for identifies this device on the LAN. These
numbers are usually shown in groups separated by periods, for example:
192.168.0.200
Subnet Mask:
Subnets allow network traffic between hosts to be separated based on the
network's configuration. In IP networking, traffic takes the form of packets. IP
subnets advance network security and performance to some level by
organizing hosts into logical groups. Subnet masks contain four bytes and
usually appear in the same "dotted decimal" data. For example, a very
common subnet mask in its binary demonstration 11111111 11111111 11111111
00000000 will usually be shown in the corresponding, more readable form as
255.255.255.0.
Gateway:
A gateway is a piece of software or hardware that passes information
between networks. You'll see this term most often when you either log in to
an Internet site or when you're transient email between different servers.
50