3. MFP Server Installation in Windows 2000/XP/Vista
3.1 Hardware Installation
1. Unpack the FPS-1010M / FPS-1010MG package and verify the items listed in the previous
section are provided.
2. Use USB cable to connect FPS-1010M / FPS-1010MG to the MFP or printer that you want
to share to your network.
3. Use a RJ-45 cable to connect the FPS-1010M / FPS-1010MG to your LAN or WAN.
4. Connect the bundled power adapter to FPS-1010M / FPS-1010MG. The MFP Server will
perform the Power-On-Self-Test (POST) after power on. Please wait for 20 seconds.
NOTE: 1. Please use the power adapter which bundled with MFP Server. DO NOT use
any other power adapter from other sources. That may cause your FPS-1010M /
FPS-1010MG damage.
2. To prevent the compatibility problem between FPS-1010M / FPS-1010MG and a
few MFP or printer, it is recommended that you power on the FPS-1010M /
FPS-1010MG before the MFP or printer.
3.2 Software Installation Procedure
This FPS-1010M / FPS-1010MG management software can be run in Windows 2000 SP4 or
above, Windows XP SP1 or above and Windows Vista. The following procedures are running
in Windows XP, the procedures are similar for Windows 2000 and Windows Vista.
NOTE: Some MFP printers will ask the user connect MFP to the PC directly and install the
printer driver, before MFP Server installation. That may cause the MFP Server
installation adds one more MFP (printer/scanner/fax/card reader) to your PC. You
can delete the devices which the MFP driver installed after MFP Server installation,
or you can keep those devices exist in your PC.
1. Insert User’s Manual and utility CD into the CD-ROM drive to initiate the autorun program.
Once completed a menu screen will appear.
2. Click on “MFP Server Utility” hyper link to initiate the installation. Or you can click the
“Start” button and choose “Run”. (Suppose “E” is your CD-ROM drive). When the dialog
box appears, enter “E:\Utility\Setup.exe” and press enter key. You will see the dialog box
as below. Please click “Next” to continue.
2
