PLUS Vision UP-800 Projector User Manual


 
E – 2
Precautions
Please read this manual carefully before using your PLUS UP-800 Data Projector and keep the
manual handy for future reference.
Your serial number is located next to the main power switch on the back of your UP-800. Record it here:
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER-SER-
VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PLUS
SERVICE PERSONNEL.
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR
MOISTURE. DO NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EXTENSION
CORD OR IN AN OUTLET UNLESS ALL THREE PRONGS CAN BE FULLY IN-
SERTED. DO NOT OPEN THE CABINET. THERE ARE HIGH-VOLTAGE COMPO-
NENTS INSIDE. ALL SERVICING MUST BE DONE BY QUALIFIED PLUS SERVICE
PERSONNEL.
DOC Compliance Notice
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
RF Interference
WARNING
The Federal Communications Commission does not allow any
modifications or changes to the unit EXCEPT those specified by
PLUS Technologies in this manual. Failure to comply with this
government regulation could void your right to operate this
equipment.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a commercial installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will
be required to correct the interference at their own expense.
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE. DO NOT USE THIS
UNIT’S GROUNDED PLUG WITH AN EXTENSION CORD
OR IN AN OUTLET UNLESS ALL THREE PRONGS CAN
BE FULLY INSERTED. DO NOT OPEN THE CABINET.
THERE ARE HIGH-VOLTAGE COMPONENTS INSIDE.
ALL SERVICING MUST BE DONE BY QUALIFIED PLUS
SERVICE PERSONNEL.
IMPORTANT INFORMATION