Filter
Top Products
E – 25
Power Menu
Horizontal Position**
Use the “Adjust” (+) button to move the image right; (–) to move it left.
Vertical Position**
Use the “Adjust” (+) button to move the image up; (–) to move it down.
Auto Picture**
Use the “Adjust” (+) button to turn this feature on so “Picture” and “Fine Picture” adjustments are
made automatically. Use the “Adjust” (–) button to turn this feature off so you can make “Picture and
Fine Picture” adjustments manually.
Picture Adjustment** (when AUTO PICTURE is off)
Use this icon with the “Fine Picture Adjustment” to fine tune the computer image or to remove any
vertical banding that might appear. This function adjusts the clock frequencies that eliminate the
horizontal banding in the image. Press the “Adjust” (+) and (–) buttons until the banding disappears.
This adjustment may be necessary when you connect your computer for the first time. This adjust-
ment is made automatically when the Auto Picture is turned on.
Fine Picture** (when AUTO PICTURE is off)
Use this icon to adjust the clock phase or to reduce video noise, dot interference or cross talk. (This
is evident when part of your image appears to be shimmering.) Use the “Adjust” (+) and (–) buttons
to adjust the image. Use the Fine Adjustment only after the Picture Adjustment is complete. This
adjustment is made automatically when the Auto Picture is turned on.
NOTE:
* Color, Tint, Sharpness and Image Mode controls will not work with an RGB source. The Tint control will
not work with a PAL or SECAM source.
** Horizontal and Vertical position controls, and Picture, Fine Picture and Auto Picture adjustments will not
work with a Video or S-Video source.
Provides access to Lamp Usage information and the Auto Start and Power Management features. Use
the “Select” button on the projector cabinet or (▲) (▼) buttons on your remote control to access a
submenu. Then press “Adjust” (+) or (–) to choose a specific option.
Lamp Usage
This tells you how long the lamp has been in operation. It is recommended that you replace a lamp
after 1000 hours of service. After you install a new lamp, select this icon and press and hold the
“Power On” button on the remote control for ten seconds to reset the lamp clock back to zero.
NOTE: The projector will turn off and be in standing by after 1100 hours of service. If this happens, press the
"Power Off" button on the remote control for ten seconds to reset the lamp clock back to zero. Do this only after
replacing the lamp.
Auto Start
Turns the Data projector on automatically when the main power switch is turned on. This eliminates
the need to always use the “Power” button on the remote control or projector cabinet. Press (+) to turn
this feature on and (–) to turn it off.
Power Management
When “Power Off” is on and there is no RGB input for five minutes or more, the projector will
automatically turn itself off. Press the (+) to turn this feature on and (–) to turn it off. This feature
does not work with Video or S-Video sources.