Filter
Top Products
E – 30
Common Problems & Solutions
Problem
Does not turn on
No picture
Image isn’t square to the screen
Picture is blurred
Image is scrollingvertically,
horizontally or both
Remote control does not work
Status indicator is lit or blinking
Cross color in RGB mode
Check These Items
• Check that the cord is plugged in and that the power switch on the back panel is
on.
• Check the status light to see if the projector has overheated or the lamp usage
exceeds 1100 hours.
• Use the menu icons to select your source (Video, S-Video, or RGB). (See page
E-23.)
• Ensure your cables are connected properly.
• Adjust the brightness and contrast.
• Remove the lens cap.
• Is the STNDBY indicator blinking?
• Reposition the projector to improve its angle to the screen.
• Adjust the focus. (See page E-7 or E-11.)
• Reposition the projector to improve its angle to the screen.
• Ensure that the distance between the projector and screen is within the adjustment
range of the lens.
• Select the source you want to input.
• Install new batteries. (See page E-28.)
• Make sure there are no obstacles between you and the projector.
• Stand within 13 feet (4m) of the projector.
See the Status Light message chart on page E-29.
If “Auto Picture” is off, turn it on. If “Auto Picture” is on, turn it off and balance
the image with the Picture Adjustment icon and Fine Picture Adjustment icon.