Filter
Top Products
4
The following will guide you through the installation of your P100 printer.
CAUTION : Limit AC power supplied to the P100
Printer to 110 - 230 V AC, 60 - 50 Hz for an
associated 680 mA - 310 mA. Limit excess current
draw to 16 amps or less, using an associated cir-
cuit breaker or other such device. Never operate
the printer in a location where operator, computer,
or printer can get wet. Personal injury could result.
The printer must be connected to an earthed
electrical power supply and properly protected
against electrical surges and grounding faults.
1. Place the printer in a location that allows easy
access to all sides. The printer should never be
operated while resting on its side or upside down.
2. Place the printers power switch in the OFF
(0) position.
3. Insert the power cable to the printer power socket
and attach to grounded electrical socket of the
proper voltage and type.
4. Attach interface cable to printer and computer and
then secure.
CAUTION: Intermittent or unpredictable operation
may occur from unsecured connectors. If damaged,
the power cable must be replaced by an exact
equivalent.
Use only Parallel Cable under 3 Meters in length.
5. Switch power on.
1.3 Printer Installation
GETTING STARTED