Filter
Top Products
User’s Guide for the Polycom Mobile Responder
2 - 6
Installing the Optional QBRI, PRI, or Serial Network Module
The Mobile Responder comes standard with an IP network interface. If you
want to connect to another network interface, such as ISDN QBRI, ISDN PRI,
or a serial network interface (V.35, RS-530, or RS-449), you must order the
optional network module, install it, and then configure the new network
interface.
You can continue to use IP with any of the optional network modules;
however, you cannot use more than one optional network module at the same
time. For example, you cannot use QBRI and V.35 at the same time.
To install the optional QBRI, PRI, or serial network module:
1. Make sure that the power is off.
Camera 1 Control
and Camera 1 In
Connect to an external camera, such as a Polycom
PowerCam or PowerCam Plus. Alternatively, you can
use the Camera 1 In connector to connect video from
a VCR or DVD player.
If you connect an external NTSC camera to the
Camera 1 In connector, the Mobile Responder’s
internal camera remains activated. However, if you
connect an external PAL camera to the Camera 1 In
connector, the internal camera is deactivated and the
screen turns blue. For information on how to proceed
once you have connected an external PAL camera,
refer to page 3-3.
LAN Connect to an IP network.
Conference-Link Connect to an external digital microphone, such as a
Polycom VSX microphone array or a SoundStation
VTX 1000 conference phone.
Because the internal microphone does not send
stereo audio, you must connect an external digital
microphone if you want to send stereo audio.
If you connect a device to the Conference-Link
connector, the Mobile Responder’s internal
microphone remains activated.
This connector... Enables you to...
1
1