Filter
Top Products
User’s Guide for the Polycom Mobile Responder
2 - 8
Powering On the Mobile Responder
After you have connected any additional equipment to the Mobile Responder,
you can connect the power cable and then power on the Mobile Responder.
The power consumption for the Mobile Responder is listed in the following
table:
To connect the power cable:
1. Open the side panel of the Mobile Responder by pressing down on the
latch. Inside the side panel is the power connector and Power button.
2. Make sure you have the appropriate power cable for your country, and
connect one end of the cable to the power connector inside the side panel.
3. Connect the other end of the power cable to a wall outlet.
To power on the Mobile Responder:
1. Press the Power button located inside the side panel to the ON position.
2. Wait one to two minutes for the system to completely power on.
When the system is powered on, the VSX 8000 home screen appears on the
display.
During this time... The power consumption is...
Startup 0.5 amp to 1 amp @ 100 - 240 VAC
Running idle 1.2 amps @ 100 - 240 VAC
LAN call 1.2 amps @ 100 - 240 VAC
Note
The Mobile Responder can accept AC voltages between 98 and 250 VAC.