Filter
Top Products
Installation
4
Powerware
®
3115 User’s Guide www.powerware.com
WARNING
This UPS contains its own energy source (batteries). The output receptacles may
carry live voltage even when the UPS is not connected to an AC supply.
Do not remove or unplug the input cord when the UPS is turned on. This removes
the safety ground from the UPS and the equipment connected to the UPS.
To reduce the risk of fire or electric shock, install this UPS in a temperature and
humidity controlled, indoor environment, free ofconductive contaminants.Ambient
temperature must not exceed 40
C (104 F). Do not operate near water or
excessive humidity (95% max).
Installing the UPS
The following steps explain how to install the UPS. See “UPS Rear
Panels” on page 6 for the rear panel of each model.
1. If you are installing the power management software, connect
your computer to the UPS communication port using the
supplied communication cable.
NOTE If you need to change the factory-set defaults for output voltage or utility
power range, see “How to Set DIP Switches” on page 10 before installing the UPS.
2. On 230V models, plug the UPS power cord into the input
connector on the UPS rear panel.
3. Plug the UPS power cord into a wall outlet or other power
source.
4. Plug the equipment to be protected into the UPS output
receptacles.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.