Filter
Top Products
The Pause Button immediately pauses the motion of the
Robotic Arm. It is also used in combination with the Pick
Button to perform a reset on the robotics.
The Sequence Button moves the Robotic Arm from one
position to the next. It is used mainly during the set-up and
testing procedures.
The Pick Button is used to manually pick up a disc and to
drop it in a Bin, the CD Recorder or the Reject area. It is
also used in combination with Pause to perform a reset in
the robotics.
The Input/Output Bins are situated on pegs around the base of
the Autoloader. This is where you stack up to 100 blank discs,
which are to be recorded and printed. The far left bin is left
empty and will be the first output bin. The Autoloader will
then keep track of which bins contain blank media and which
bins will accumulate finished output.
The Reject Area is where discs are dropped if they do not pass
a software verification test. Discs simply drop in the left bin of
the Disc Publisher.
Rear Panel
This illustration shows the input ports found on the rear panel
of the Autoloader:
The Power port connects to a 12v 5 amp power converter.
The USB port connects to a standard 6' USB cable. Plug the
other end directly into a USB port on the back of your
computer.
4 Getting Started
Power Input Port USB Port
510975.qxd 9/28/2006 9:39 AM Page 4
INDEX
TOC