Filter
Top Products
Clean Cartridge
Cartridges that sit idle in the Publisher for a period of time
may start to experience some drying of ink in the tiny nozzles
that make up the print head. Clicking the Clean Cartridge
button will cause the Publisher to pick a disc and place in into
the printer tray. The Publisher will then print a simple pattern
that will flush ink through the nozzles. The test pattern will
also show you if any nozzles are clogged. In the pattern you
will see some diagonal lines which should be continuous;
breaks in those lines indicate a clogged nozzle. Please note
that it may require more than one cleaning to fully clear all
nozzles. If the nozzles are not fully clear after a few cleaning
prints, it may be necessary to remove the cartridge and
actually clean the print head by gently blotting the nozzles
with a moist cloth or paper towel and replace it in the
Publisher.
Change Cartridge
If you need to change cartridges, it is a good idea to use the
Change Cartridge button in the Configuration Utility. This
ensures the most accurate tracking of ink levels. To change a
cartridge, click the Change Cartridge button. The cartridge
holder will move to the center of the Publisher to make it
easier to install the cartridges. Lift the top cover and install
the cartridges and described in Section 2 of this manual. Once
installed, click the OK button and the system will update your
cartridge levels.
Alignment Calibration Print
The Cartridge Alignment prints a test print and then
automatically scans the print to configure your printer for
bidirectional printing and to align the color and black
cartridges for Color+Black printing. It is important to perform
this calibration every time you change a cartridge. If you forget
to perform this calibration you will be prompted to do so
before your first print from the new cartridge.
Creating Discs on a Mac 45